• Vektek accessory valve designs are specifically intended for use in hydraulic clamping systems.
• Steel components, hardened operating parts and flow rates matched to the demands of workholding.
• Vektek valves will deliver safe, reliable long-life.
• Vektek accessory valves prevent system damage and erratic operation frequently experienced through the use of valves designed for general industrial applications.
• Sequence Valves' two-port design eliminates the need for a third fluid line to drain bypass flow (internal leakage) back to system reservoir.

The new In-port Flow control can be used on all standard manifold mounted Swing Clamps and on both high and low pressure Link Clamps. These tiny units may be especially useful for flexible part applications where components must clamp at nearly the same time.

• Time clamp on sensitive fixtures
• Reverse free flow check valve
• Smallest high pressure flow control on the market
• Prevent component cam damage from unexpected or accidental surges in flow rate>
• Use with single or double acting Swing Clamps
• Flow control requires use of manifold mount ports

For proper sealing,the mating 
surface must be flat within 
0.08 mm with a maximum 
surface roughness of 1,6 mµ R_a

For proper sealing, the mating surface must be flat within 0.08 mm with a maximum surface roughness of 1,6 mµ R_a

Operation: The VektorFlo^® sequence valve operates as a pressure sensitive, normally closed element in a clamp­ing system. When fluid first enters the sys­tem at low pressure, the valve is closed, blocking the flow of fluid to devices down­stream. After devices up­stream of the valve have moved into position and pressure begins to increase, the in­creas­ing pressure overcomes the spring force holding the valve closed, forcing the poppet off its seat al­low­ing fluid flow through the valve. After downstream devices have positioned and clamped, and pressure has increased to equal upstream pressure, the entire system pressure rises to the maximum level setting on the hydraulic power supply. When un­clamp­ing, as pressure falls, force from the adjustment spring pushes the poppet back onto its seat. Fluid trapped in the down­stream circuit flows back through the check valve to return to the power unit reservoir.

Low Pressure PRV added to the Product Line

For proper sealing, the mating surface 
must be flat within 0.08 mm with a maximum surface roughness of 1,6 mµ R_a

• Switch Tested over a 1,000,000 lifetime.
• New sealed collar and micro-switch designs guard against liquid or coolant leaks; making this switch ideal for use in moisture environments.
• M8 connectors fafford more standard wiring options. 
• Superior reinforced cable connections that withstand stress, seal securely and are easily changed or serviced.
• Pressure range between 55 bar (5,5 MPa) and 350 bar (.5MPa)
• Sealed switch for operation in high moisture environments.(Complies with IP 67)
• Reset deadband : approximately 5% of the set pressure.
•  Electrical Rating